| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| In the Linux kernel, the following vulnerability has been resolved:
smb: client: reject SetEA requests that do not fit the request buffer
CIFSSMBSetEA() copies the caller's extended attribute value into the
SMB request buffer without checking that it fits. The requirement is
stated in the source but was never implemented:
/*BB add length check to see if it would fit in
negotiated SMB buffer size BB */
/* if (ea_value_len > buffer_size - 512 (enough for header)) */
if (ea_value_len)
memcpy(parm_data->list.name + name_len + 1,
ea_value, ea_value_len);
The only bound applied on the way in is in cifs_xattr_set():
#define MAX_EA_VALUE_SIZE CIFSMaxBufSize
...
if (size > MAX_EA_VALUE_SIZE)
CIFSMaxBufSize is the full payload capacity of the buffer, so a value
of exactly that size leaves no room for the SMB header, the TRANS2
parameter block, the fealist header and the EA name that are written
ahead of it in the same object.
SendReceive() already enforces the correct limit on this very length:
if (in_len > CIFSMaxBufSize + MAX_CIFS_HDR_SIZE)
but it is called after the copy has taken place. An unprivileged
setxattr(2) on an SMB1 mount with a 250-byte name and a 16384-byte
value writes 16384 bytes starting 345 bytes into a 16588-byte
cifs_request object, ending 141 bytes past it:
BUG: KASAN: slab-out-of-bounds in CIFSSMBSetEA+0xabc/0xde0
Write of size 16384 at addr ffff888003aa0159 by task init/68
__asan_memcpy+0x3c/0x60
CIFSSMBSetEA+0xabc/0xde0
cifs_xattr_set+0xd3a/0xff0
__vfs_setxattr+0x13e/0x1a0
The buggy address is located 345 bytes inside of
allocated 16588-byte region
Apply SendReceive()'s limit to the assembled request before the copy
rather than after it, and widen the byte counters so the sum cannot
wrap before it is tested.
byte_count is also tested against U16_MAX, because it is stored in the
16-bit pSMB->ByteCount. That becomes reachable when CIFSMaxBufSize is
raised at module load, where it may be set as high as 1024*127: with a
5-byte EA name and a 65521-byte value, count is exactly U16_MAX while
byte_count is 65556, and cpu_to_le16() would truncate it to 20 and
transmit a frame whose ByteCount does not match its length. Testing
byte_count covers count as well, since byte_count is the larger of the
two and count's only 16-bit consumer is written after this point.
check_add_overflow() is evaluated first so that total_len is assigned
before it is reported. |
| In the Linux kernel, the following vulnerability has been resolved:
smb: client: fix data corruption with concurrent writes and O_TRUNC
cifs_do_truncate() flushes dirty pages with filemap_write_and_wait()
and truncates the file on the server, but in the old code both
operations ran without holding i_rwsem or invalidate_lock. A
concurrent buffered write via netfs_perform_write() -- which only
needs i_rwsem shared -- could dirty new pages after the flush but
before the local truncation, and those pages would be silently
discarded by cifs_setsize() -> truncate_pagecache().
Fix by acquiring inode_lock (exclusive i_rwsem) and
filemap_invalidate_lock at the top of cifs_do_truncate(), so the
entire flush-truncate-resize sequence is atomic with respect to:
- buffered writes (blocked by exclusive i_rwsem, since
netfs_start_io_write takes i_rwsem shared),
- read page faults (blocked by exclusive invalidate_lock, since
filemap_fault takes it shared),
- writeback collection (blocked by netfs_wb_begin/netfs_wb_end
around the server truncate and local resize, since
netfs_writepages also acquires the wb lock). |
| In the Linux kernel, the following vulnerability has been resolved:
net/sched: cls_flower: validate mask pointer after nla_next()
fl_set_enc_opt() iterates the key's nested tunnel-option attributes
with nla_for_each_attr() while advancing a single mask pointer via
nla_next() at the bottom of each loop, so the mask cursor is driven
by the number of key attributes rather than by the mask's own
attributes. The nla_ok() added by commit c96adff956191 ("cls_flower:
call nla_ok() before nla_next()") only validates the mask pointer
that was just consumed; the pointer produced by nla_next() is used by
the next iteration (fl_set_geneve_opt() and siblings) without any
validation.
The mask's nested attributes are validated with NL_VALIDATE_LIBERAL,
which merely warns on trailing bytes that do not form a complete
attribute. A mask carrying one valid attribute plus 1-3 residue
bytes (or a non-aligned attribute length making msk_depth negative)
therefore reaches the next iteration with msk_depth != 0, so neither
the !msk_depth check in fl_set_enc_opt() nor the !depth check in the
per-type helpers fires. nla_type() then reads past the mask payload
and nla_parse_nested_deprecated() iterates with an nla_len taken
from those bytes, reading well beyond the mask attribute (KASAN:
slab-out-of-bounds read in __nla_validate_parse from fl_change()).
Validate the advanced mask pointer as well: when the mask is not
legitimately exhausted (msk_depth != 0) and the new pointer fails
nla_ok(), reject the filter with -EINVAL. An exactly exhausted mask
still skips the check, preserving exact-match behaviour for the
remaining key attributes. |
| In the Linux kernel, the following vulnerability has been resolved:
net/sched: fix use-after-free in __tcf_action_put()
__tcf_action_put() decrements the reference count before decrementing the
binding count. Another thread can free the action between these operations,
causing the binding-count update to access freed memory. KASAN reports it
as:
BUG: KASAN: slab-use-after-free in __tcf_action_put+0x327/0x340
Write of size 4 at addr ff11000000d46420 by task tc-put-pause/64
Hold the action IDR mutex across both counter updates and IDR removal,
keeping cleanup outside the lock. |
| Missing Authorization vulnerability in Crocoblock JetEngine jet-engine allows Exploiting Incorrectly Configured Access Control Security Levels.This issue affects JetEngine: from n/a through 3.9.0.1. |
| IBM Langflow OSS 1.0.0 through 1.12.4 could allow a remote attacker to obtain sensitive information due to improper authentication. |
| IBM Langflow OSS 1.0.0 through 1.12.4 could allow a remote authenticated attacker to execute arbitrary commands due to improper control of code generation. |
| An Exposed IOCTL with Insufficient Access Control vulnerability [CWE-782] vulnerability in Fortinet FortiClientWindows 7.4.0 through 7.4.3, FortiClientWindows 7.2.0 through 7.2.9 may allow an authenticated local user to execute unauthorized code via fortips driver. Success of the attack would require bypassing the Windows memory protections such as Heap integrity and HSP. In addition, it requires a valid and running VPN IPSec connection. |
| Heap-based buffer overflow in Microsoft Edge (Chromium-based) allows an unauthorized attacker to execute code over a network. |
| Heap-based buffer overflow in Microsoft Edge (Chromium-based) allows an unauthorized attacker to execute code over a network. |
| Heap-based buffer overflow in Microsoft Edge (Chromium-based) allows an unauthorized attacker to execute code over a network. |
| Double free in Microsoft Edge (Chromium-based) allows an unauthorized attacker to execute code over a network. |
| Szafir accepts any client or server certificate without performing certificate and hostname validation, allowing HTTPS connections without authenticating the remote server. An attacker can provide an arbitrary SSL/TLS certificate and cause the application to download an update file from their server.
This issue was fixed in version 2.0 build 708. |
| Szafir is vulnerable to Path Traversal in the uploaded filename. A man-in-the-middle attacker who can reroute update request to their server can prepare arbitrary XML file that will be saved in location chosen by attacker.
This issue was fixed in version 2.0 build 708. |
| Szafir and Szafir Weryfikująca are vulnerable to XML External Entity (XXE) injection. When a user signs or verify a crafted XML file containing a `DOCTYPE` with an external DTD reference, the parser processes external entities, allowing an attacker to read arbitrary files from the victim's filesystem.
This issue was fixed in Szafir version 2.0 build 708. Szafir Weryfikująca is no longer supported (End of Life) and has not been fixed. |
| Improper Neutralization of Input During Web Page Generation ('Cross-site Scripting') vulnerability in POSIMYTH Innovations The Plus Addons for Elementor Page Builder Lite the-plus-addons-for-elementor-page-builder allows Stored XSS.This issue affects The Plus Addons for Elementor Page Builder Lite: from n/a through 6.5.3. |
| A vulnerability in the Remote Access SSL VPN service of Cisco Secure Firewall Adaptive Security Appliance (ASA) Software and Cisco Secure Firewall Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to cause the device to reload unexpectedly, resulting in a denial of service (DoS) condition. This vulnerability is due to logic errors when secondary authentication is configured on a tunnel group. An attacker could exploit this vulnerability by sending a crafted request when connecting to the SSL remote access VPN. A successful exploit could allow the attacker to cause the affected device to reload, resulting in a DoS condition. |
| A vulnerability was identified in Ndemic Creations Plague Inc Evolved up to 1.24.0.3. The affected element is an unknown function of the component Workshop Scenario Loader. Such manipulation leads to deserialization. The attack may be performed from remote. Upgrading to version 1.24.0.4 is sufficient to fix this issue. It is recommended to upgrade the affected component. |
| Use after free in Windows Message Queuing Queue Manager allows an authorized attacker to execute code locally. |
| Missing Authorization vulnerability in weDevs Happy Addons for Elementor happy-elementor-addons allows Exploiting Incorrectly Configured Access Control Security Levels.This issue affects Happy Addons for Elementor: from n/a through 3.50.1. |
